Get quotes

Lux and lumens calculator

Choose the area, enter its size and the fitting you have in mind, and see how many lights it takes to reach the recommended light level.

Lights needed for an area

lux
Filled in from the area above; change it if you have a specification.
m
m
Type of fitting
lm
On the spec sheet. A 30 W LED flood light gives about 3,000 lm.

Result

Fittings needed–
Total lumens of fittings–
Area–
Light needed on the area–
Approximate LED power–
Average with that many fittings–

Lumens are what a fitting puts out; lux is how much of that light lands on each square metre. A security yard needs far less light than a tennis court, and a light aimed straight at the ground wastes less than one mounted on a wall. Start from the lux the area needs and work back to the number of fittings.

The formula

Lumens needed = lux × area (m²) ÷ (utilisation factor × maintenance factor)

The utilisation factor is the share of a fitting's light that actually reaches the area. Flood lights with a defined beam, aimed at the ground, get about 55% of their light onto it; wall and pole lights lighting an open area about 40%; low bollards and path lights, which throw much of their light sideways, about 30%.

The maintenance factor of 0.8 allows for LEDs dimming with age and dirt on the lens, so the area still meets the target after a few years. Divide by the lumens of one fitting to get the number of fittings, then round up.

Recommended light levels outdoors

The levels in the calculator are typical design values, based on the European outdoor workplace and sports lighting standards (EN 12464-2 and EN 12193) that South African lighting designers commonly use.

  • 5 to 10 lux: garden paths, steps and estate walkways
  • 10 to 20 lux: home driveways, car parks and perimeter security lighting
  • 50 lux: entrances, braai and entertainment areas, loading bays
  • 75 to 200 lux: soccer, rugby and hockey training to club matches
  • 200 to 500 lux: tennis, netball and padel, recreational to competition

More light is not always better. Over-lit yards create deep shadows next to bright patches, glare for cameras and neighbours, and complaints in estates. Even light with good uniformity matters more than a high average.

Lumens per watt

Good outdoor LED fittings give 100 to 140 lumens per watt; cheap ones may give 70 or less, and old halogen flood lights about 20. The calculator estimates power at 110 lm/W. Compare quotes on lumens and lm/W, not on watts alone, and check the beam angle and IP rating. See flood lights and LED outdoor lighting.

When to ask for a lighting design

This calculator gives a good first estimate for simple rectangles. For sports fields, large car parks, estate roads or anywhere uniformity and glare matter, ask suppliers for a DIALux or Relux lighting layout: a computer model that shows the lux at every point. Most sports field lighting and street lighting suppliers provide one free with a quote.

Frequently asked questions

What is the difference between lux and lumens?
Lumens measure the total light a fitting gives out. Lux measures how much light falls on a surface: one lux is one lumen spread over one square metre. A 3,000 lm flood light lighting 100 m² with half its light gives about 15 lux.
How many lumens do I need for a driveway?
A home driveway needs about 10 to 20 lux. A 6 × 15 m driveway (90 m²) at 20 lux with wall or pole lights needs about 5,600 lumens of fittings, for example two 3,000 lm lights or four 1,500 lm lights spread along it.
How much light does a security yard need?
Around 10 to 20 lux for general perimeter and yard security, and 50 lux where people work at night, such as loading bays. Even coverage without dark corners matters more than brightness, especially for CCTV.
How bright should tennis court lights be?
About 200 to 300 lux for social and club tennis and 500 lux for competitions, with very even light across the court. A typical tennis court needs 6 to 8 LED flood lights of 200 to 300 W each on 8 m poles.

More outdoor lighting tools

Results are estimates for planning and comparing quotes. They don't replace a site visit, a lighting design or an electrician's calculation to SANS 10142-1.

Get outdoor lighting quotes

List the fittings you have in mind, or just describe the job. Suppliers and electricians who work in your area quote you directly. Free, no obligation.

Fixture schedule

RefFitting, finish or modelQtyPowerRemove
L1
L2
L3
Up to 20 lines. Not sure what you need? Leave this empty and describe the job.

No fittings yet

Free and no obligation. By sending you agree that we may share your request with a suitable supplier or electrician. See our privacy policy.

Get free lighting quotes