Spacing decides whether a path reads as one continuous line of light or a row of bright spots with dark gaps between. The higher a light is mounted, the wider its pool and the further apart the fittings can be. A spacing of a few times the mounting height is the starting point designers use.
The spacing rule
Spacing = mounting height × spacing ratio
The ratio depends on how wide the fitting spreads its light. Low path lights and bollards throw light sideways and down, so they are spaced at about 4 to 5 times their height. Wall lights along a facade work at 2 times their mounting height for an even wash. Lamp posts and street lights with wide road optics manage 3 to 4 times their height.
The calculator then fits the nearest whole number of lights into the length, with one at each end, and gives the actual spacing. Choose even for overlapping pools (steps, busy paths, estate roads) or accent for separate pools of light, which suits gardens and looks calmer at night.
Typical spacing
- Garden path lights, 0.4 to 0.6 m high: 1.5 to 3 m apart, staggered on both sides of wide paths
- Bollards, 0.6 to 1.1 m: 3 to 6 m apart along driveways and walkways
- Wall lights at 1.8 to 2.2 m: 3 to 5 m apart along a wall, or one each side of a door or garage
- Garden lamp posts, 2.5 to 4 m: 8 to 14 m apart
- Estate street lights, 6 to 8 m: 20 to 30 m apart, usually on one side of the road
- Yard flood lights on 6 to 10 m poles: 15 to 25 m apart
See bollard lights, outdoor pole lights and street lights.
One side, opposite or staggered
On paths up to about 1.5 m wide and most driveways, one row of lights is enough. On wider paths and roads, staggered lights on alternate sides give even light with the same number of fittings as one row. Opposite pairs look formal and suit entrances and avenues but need twice as many fittings. Always add a light at changes in level, steps, gates and corners, even if it breaks the rhythm.
Before you dig
Lay the lights out on the ground and look at them after dark before trenching, or use battery or solar fittings as a test. Plan the cable route and junction points, and keep lights clear of where cars turn. For estates, check the HOA rules on light spill and fitting styles. A landscape lighting designer can draw a full plan.
Frequently asked questions
How far apart should bollard lights be?
How far apart should path lights be?
How far apart are street lights in an estate?
How many wall lights do I need along a wall?
More outdoor lighting tools
- Solar light calculatorSize the panel and battery a solar light needs to last through a South African winter night.
- Lux and lumens calculatorHow many lumens, and how many flood or pole lights, a driveway, yard, car park or sports court needs.
- Running cost calculatorWhat your outdoor lights cost on the electricity bill each month, and how fast switching to LED pays back.
- Cable and voltage drop calculatorCheck the cable size for a 12 V, 24 V or 230 V garden lighting run, and size the transformer.
- Beam angle calculatorHow wide a spotlight's beam is at a given distance, how bright it is, and which beam angle suits a tree or wall.
- IP rating guideDecode any IP rating and see which one an outdoor light needs on a wall, in the ground, by the sea or in a pool.
Results are estimates for planning and comparing quotes. They don't replace a site visit, a lighting design or an electrician's calculation to SANS 10142-1.