Outdoor lights are on for hours every night, so small differences in wattage add up. A single 500 W halogen flood light left on a timer from dusk to midnight can cost more each month than all the LED garden lights on the property together. Enter your lights below to see where the money goes.
How the cost is worked out
Monthly cost = watts × number of lights × hours per night × 30.4 days ÷ 1,000 × tariff (R/kWh)
Use the real power of the fitting, printed on the fitting, the lamp or the driver, not the "equivalent" wattage on LED packaging. For a sensor light, estimate how long it is actually on: usually 15 to 60 minutes a night rather than the whole night.
The default tariff of R3.90 per kWh is a typical 2026 residential rate including VAT. Municipal tariffs vary from under R3 to over R5 per kWh depending on the city, the block you're in and whether you're on prepaid. Check your latest bill or prepaid slip and enter your own rate.
What switching to LED saves
LED outdoor fittings use 75 to 90% less power than halogen and incandescent lamps for the same light, and last 25,000 to 50,000 hours instead of 1,000 to 2,000. The payback section shows how many months the saving takes to cover the cost of the new LEDs. For lights that are on all night, it is often under a year.
- 500 W halogen flood light → 50 W LED flood light
- 60 W incandescent wall light → 7 to 9 W LED lamp or fitting
- 50 W halogen MR16 spike spotlight → 5 to 7 W LED
- 150 W HPS or mercury street light → 40 to 60 W LED
See LED outdoor lighting for fittings and retrofit lamps.
Cutting the bill further
- Photocells switch lights on at dusk and off at dawn, so nobody forgets them on in the morning.
- Timers and smart switches turn decorative lighting off at bedtime while security lighting stays on.
- Motion sensors keep security flood lights off until someone moves, often cutting their running time by 90%.
- Dimming garden and path lights to 50% after 10 pm halves their cost and is kinder to neighbours and wildlife.
- Solar for gates, walls and paths takes them off the bill and keeps them on during load-shedding. Try the solar light calculator.
Lights during load-shedding
If your outdoor lights run from a backup inverter and battery, their power also decides how long the battery lasts. Ten 10 W LED lights for four hours use 400 Wh, about 8% of a 5 kWh battery; the same light from ten 50 W halogens would use 2 kWh. Cutting outdoor wattage is one of the cheapest ways to stretch backup power. An electrician can put outdoor lights on their own circuit so you can choose which run on backup.
Frequently asked questions
How much does it cost to run an outdoor light all night?
Do LED lights use less electricity?
What is a kWh?
Is it cheaper to leave outdoor lights on or use a sensor?
More outdoor lighting tools
- Solar light calculatorSize the panel and battery a solar light needs to last through a South African winter night.
- Lux and lumens calculatorHow many lumens, and how many flood or pole lights, a driveway, yard, car park or sports court needs.
- Cable and voltage drop calculatorCheck the cable size for a 12 V, 24 V or 230 V garden lighting run, and size the transformer.
- Light spacing calculatorHow far apart to put path lights, bollards, wall lights, lamp posts and street lights, and how many you need.
- Beam angle calculatorHow wide a spotlight's beam is at a given distance, how bright it is, and which beam angle suits a tree or wall.
- IP rating guideDecode any IP rating and see which one an outdoor light needs on a wall, in the ground, by the sea or in a pool.
Results are estimates for planning and comparing quotes. They don't replace a site visit, a lighting design or an electrician's calculation to SANS 10142-1.